M300 Wind Turbine Generator
1. Technical Parameter
| Model | M300 |
| Rated Voltage(DCV) | 12/24 |
| Rated output(W) | 90 |
| Start-up wind speed(m/s) | 1 |
| Survival wind speed(m/s) | 35 |
| Rotor diameter(m) | 0.82 |
| Blades No.(pcs) | 6 |
| Blade material | Reinforced fiber glass |
| Nacelle material | Aluminum |
| Controller | Built-in |
| Protection mode | Short circuit |
| Lifetime(years) | 25 |
| Packing form | carton |
| Protection grade | IP65 |
2. Power Curve
3. Structure
4. Special note
Connection diagram between wind generator andpole
1.Connectsmall pole and pipe(48*2.5mm diameter).
2.Drill 2pcs of symmetrical screw holes(12mm diameter) above a diatance of20mm at the upper end of pipe.
3.Clockwise 90°in thehole above the distance of 20mm, and drill2pcs of symmetrical screw holes(12mmdiameter) above a diatance of 38mm at the upper end of pipe.
4.Fasten the pipe between wind generator and tower with 4pcs screws(M10).
Note: The joints betweenwind generator and pole need a torque of 80nm. Fix with locking grain rubber insuitable condition.
Contact telephone：
ICP备案号 Copyright © 2016 江苏神州新能源电力有限公司 | 技术支持：左右互联
